Search
Now showing items 1-10 of 17
Design of the analog front end circuit for X-ray detectors
(Dhirubhai Ambani Institute of Information and Communication Technology, 2009)
The Thesis presents a novel idea to efficiently read out the value corresponding to incident X-Ray, from X-Ray sensor. A system level solution has been proposed which is unique in itself in terms of approach. A simple ...
ASIC implementation of discrete fourier transform processing module
(Dhirubhai Ambani Institute of Information and Communication Technology, 2007)
This work presents the design and ASIC implementation of Discrete Fourier Transform Processing Module. The performance of designed DFT processing module is better than radix-2 and radix-4 FFT algorithms, and is comparable ...
Statistical delay modeling and analysis for system on chip
(Dhirubhai Ambani Institute of Information and Communication Technology, 2006)
It is seen that designing using conventional methodologies in Deep Sub Micron geometries, at times, ends up in very pessimistic design and less yield. This is because, today’s tools don’t consider statistical variation of ...
Design of low-voltage, low-power, wide-band CMOS LC VCO using active inductors
(Dhirubhai Ambani Institute of Information and Communication Technology, 2008)
In this thesis the design of low-voltage, low-power, wide-band CMOS LC VCO using active inductor has been proposed. The oscillator is based upon the classic LC-tuned negative-resistance topology, with a novel active inductor ...
Analysis and modeling of power distribution network and decoupling network design strategies for high speed digital and analog VLSI system
(Dhirubhai Ambani Institute of Information and Communication Technology, 2009)
Today’s high speed digital and analog VLSI systems are operating in GHz frequency range. With high switching rate of the devices, power distribution network (PDN) impedance causes ripples in power supply. If PDN is not ...
Adaptive biased switched capacitor filters
(Dhirubhai Ambani Institute of Information and Communication Technology, 2008)
The demand from today’s handheld devices, such as laptop, ipod, cellphones is to have a long battery life with no compromises in speed. The devices dissipate power even in standby mode also. Op-amp is a major block in all ...
Built-in self test architecture for mixed signal systems
(Dhirubhai Ambani Institute of Information and Communication Technology, 2009)
Built-in self test architecture or BIST as we call them, are the necessity of time since the shrinking sizes of component on-chip with advance in IC technology are making it BIST artistries are being rapidly developed and ...
Design of a CMOS variable gain amplifier
(Dhirubhai Ambani Institute of Information and Communication Technology, 2008)
In advanced CMOS technologies as device dimensions are decreasing, requirement for lower supply voltages are increasing to make certain device reliability. So, challenges for analog circuit designers are to discover new ...
Design of voltage reference circuits
(Dhirubhai Ambani Institute of Information and Communication Technology, 2008)
Shrinking device dimensions in advancing CMOS technologies require lower supply voltages to ensure device reliability. As a result, analog circuit designers are faced with many challenges in finding new ways to build analog ...
Low power SRAM design
(Dhirubhai Ambani Institute of Information and Communication Technology, 2008)
In the past, power dissipation was not constraining factor because of device density and operating frequency was low enough. But nowadays due to increased integration and operating frequency of integrated circuits, power ...